在線咨詢
官方二維碼
當前位置：
2022.10.21
沼氣發電機組沼氣裝置的故障排除方法
按沼氣發電機組的檢查方法排查一下沼氣發電機組的工作情況，斷缸試驗，看是否個別缸不工作或工作不好，每缸作比較；有無氣缸漏氣現象；氣門間隙是否正常。在確定上述部位沒有故障，判定故障可能發生在沼氣裝置上。故障排除方法：
Check the working condition of the biogas generator set according to the inspection method of the biogas generator set, and conduct cylinder cutout test to see whether individual cylinders do not work or do not work well, and compare each cylinder; Whether there is air leakage in the cylinder; Check whether the valve clearance is normal. After confirming that there is no fault in the above parts, it is determined that the fault may occur in the biogas device. Troubleshooting:
1)沼氣動力閥間隙太小，沼氣流量不夠，混合氣過稀。調整動力閥，沼氣發電機組的動力閥裝在減壓器出氣口，動力閥有刻度，R(-)方向?yàn)闇p小，L(+)方向?yàn)樵龃蟆?/div>
1) The clearance of biogas power valve is too small, the biogas flow is not enough, and the mixture is too thin. Adjust the power valve. The power valve of the biogas generator set is installed at the outlet of the pressure reducer. The power valve has a scale. The R (-) direction decreases, and the L (+) direction increases.
2)檢查沼氣過濾器有無堵塞。
2) Check whether the biogas filter is blocked.
3)檢查壓力平衡管是否漏氣或破損。
3) Check whether the pressure balance pipe leaks or is damaged.
4)增壓中冷系統是否有漏氣，檢查排氣管墊、增壓器接口、中冷器、混合器、進氣管及各連接硅膠管，增壓器有無損害。
4) Check the exhaust pipe gasket, turbocharger interface, intercooler, mixer, intake pipe and all connecting silicone hoses of the supercharger for damage.
5)排氣管道或三元催化器堵塞，致排氣阻力增大。
5) The exhaust pipe or three-way catalyst is blocked, resulting in increased exhaust resistance.
6)檢查空氣濾清器是否良好，進氣管路是否暢通。
6) Check whether the air filter is in good condition and whether the air inlet pipe is unblocked.
7)檢查沼氣步進電機及減壓器出氣口到混合器之間的管路。
7) Check the pipeline from biogas stepper motor and pressure reducer outlet to mixer.
8)混合器皮膜破損，不能形成合理的空燃比，更換皮膜。
8) The skin film of the mixer is damaged and cannot form a reasonable air fuel ratio. Replace the skin film.
9)中低壓減壓閥二級閥片行程過小。
9) The stroke of the secondary valve plate of the medium and low pressure reducing valve is too small.
10)減壓器電磁閥閥芯、閥孔是否破損，進氣量不夠，更換電磁閥。
10) If the solenoid valve core and valve hole of the pressure reducer are damaged and the air intake is insufficient, replace the solenoid valve.
11)檢查低減壓器的膜片、彈簧、桿桿有無損害。
11) Check whether the diaphragm, spring and rod of the low pressure reducer are damaged.
沼氣發電機組沼氣裝置的故障排除方法相關內容就講解到這里了，您對此有什么注意事項就來我們網站http://pyucoin.com咨詢了解吧！
This is the end of the troubleshooting of biogas generator set and biogas device. If you have any precautions, please come to our website http://pyucoin.com Ask and understand!