在線咨詢
官方二維碼
當前位置：
2022.05.27
發電機組的正常操作流程
開機啟動準備工作
Preparation for startup
1、 檢查發電機緊固件、連接件是否松動，活動部件是否靈活。
1. Check whether the fasteners and connecting pieces of the generator are loose and whether the moving parts are flexible.
2、 檢查燃油、機油及冷卻水的儲量是否滿足使用要求。
2. Check whether the reserves of fuel, engine oil and cooling water meet the use requirements.
3、 檢查控制柜上的負載空氣開關，應在斷開位置，并將電壓旋鈕整定在電壓更小的位置上。
3. Check that the load air switch on the control cabinet should be in the off position, and set the voltage knob to the minimum voltage position.
4、 焦化發電機組開機前的準備工作，嚴格按照使用操作說明書要求進行。
4. The preparation before startup of the coking generator unit shall be carried out in strict accordance with the requirements of the operation manual.
5、 必要時，通知供電部門拉下斷路器開關，切斷市電高壓供電線路。
5. If necessary, inform the power supply department to pull down the circuit breaker switch and cut off the high-voltage power supply line of the mains.
啟動步驟
Startup steps
1、空載啟動焦化發電機組按使用說明規定的方法進行啟動。
1. Start the coking generator unit without load according to the method specified in the instructions.
2、按柴油發電機的說明書要求調整轉速和電壓。
2. Adjust the speed and voltage according to the instructions of the diesel generator.
3、一切正常后，將負載開關切換至發電機端，按倒閘操作順序，逐級合上負荷開關，使之進入工作供電狀態。
3. After everything is normal, switch the load switch to the generator end, and close the load switch step by step according to the switching operation sequence to make it enter the working power supply state.
4、運行中時刻注意三相電流是否平衡，各電氣儀表指示是否正常。
4. During operation, always pay attention to whether the three-phase current is balanced and whether the indication of each electrical instrument is normal.
運行注意事項
Operating precautions
1、 定時檢查水位、油溫及油壓的變化情況，并做好記錄。
1. Regularly check the changes of water level, oil temperature and oil pressure, and make records.
2、 出現漏油、漏水、漏氣情況要及時修復，必要時停止發電機工作。
2. In case of oil, water and air leakage, it shall be repaired in time, and the generator shall be stopped if necessary.
發電機停機注意事項
Precautions for generator shutdown
1、 逐級切斷負載，斷開自動空氣開關。
1. Cut off the load step by step and disconnect the automatic air switch.
2、 按照焦化發電機組配備的使用說明書進行停機。
2. Shut down according to the operating instructions provided for the coking generator unit.
3、 做好發電機的清潔衛生工作。
3. Clean the generator.
所以無論是安裝還是日常檢修維護，多要對發電機組有足夠的重視。更多相關內容就來網站pyucoin.com咨詢了解吧！
Therefore, whether it is installation or routine maintenance, it is necessary to pay enough attention to the generator set. For more information, please visit www.huannengpower Www. 68mn!