日韩不卡视频在线观看一区_亚洲国产精品久久久久久6p_区三区日韩免费毛片_亚洲精品久久一区二区三区四区_精品国产电影久久官网_婷婷五月天视频_久久久国产成人片_婬乱久久久久_伊人久久大香线蕉av蜜芽_不卡在线中文字幕av

歡迎進入濟南濟柴環能燃?xì)獍l(fā)電設備有限公司官網!
當前位置:首頁 - 新聞中心 - 常見問題解答

常見問題解答

水輪發電機組運行維護要注意什么?

返回 2022.01.25 來源:http://pyucoin.com 0
(1)機組運行中,注意調速器油壓表與壓油槽油壓表的指示不能相差過大。
(1) During the operation of the unit, pay attention that the indication of the governor oil pressure gauge and the oil pressure gauge of the oil pressure tank shall not differ too much.
(2)機組在停機過程中,應盡量縮短低轉速運行時間。當轉速下降至額定轉速的35%~40%時,可加閘制動。
(2) During the shutdown of the unit, the operation time at low speed shall be shortened as far as possible. When the speed drops to 35% ~ 40% of the rated speed, the brake can be added.
(3)機組在運行中,導水葉的開度限制應放在機組大出力的限制位置。當機組起動與系統并列時,如發現調速系統不穩定,可用開度限制使其穩定。在與系統并列后,可將開度限制放在機組大出力限制的位置。
(3) During the operation of the unit, the opening limit of the guide vane shall be placed at the limit position of the maximum output of the unit. When the unit is started in parallel with the system, if the speed regulation system is found to be unstable, the opening limit can be used to make it stable. After parallel with the system, the opening limit can be placed at the position of the maximum output limit of the unit.
(4)定期檢查主軸的擺度。
(4) Regularly check the swing of the spindle.
(5)機組運行中,還應定期做如下工作:
(5) During the operation of the unit, the following work shall also be done regularly:
1)定期切換壓油裝置的油泵和導軸承油泵,以防電動機受潮。
1) Regularly switch the oil pump and guide bearing oil pump of the oil pressure device to prevent the motor from moisture.
焦化發電機組
2)調速器各杠桿的連接處要定期注油。
2) The connection of each lever of the Governor shall be filled with oil regularly.
3)各汽水分離器要定期放水。
3) Each steam water separator shall discharge water regularly.
4)定期清掃橡膠水導軸承潤滑水的過濾器。
4) Clean the filter of lubricating water of rubber water guide bearing regularly.
5)機組備用時,定期做橡膠水導軸承備用潤滑水的投入試驗。
5) When the unit is in standby, the standby lubricating water of rubber water guide bearing shall be put into test regularly.
6)定期向蝶閥軸承注油。
6) Fill the butterfly valve bearing regularly.
焦化發電機組專注為您提供新鮮的行業資訊,更多的問題及精彩內容請關注我們的網站:http://pyucoin.com,我們會有更多的精彩內容為您
Coking generator set focuses on providing you with fresh industry information. For more questions and wonderful contents, please pay attention to our website: http://pyucoin.com , we will have more wonderful content for you
新聞搜索
濟南濟柴環能燃?xì)獍l(fā)電設備有限公司
  • 服務熱線

    0531-62325028
    0531-69951266

水輪發電機組運行維護要注意什么?

(1)機組運行中,注意調速器油壓表與壓油槽油壓表的指示不能相差過大。
(1) During the operation of the unit, pay attention that the indication of the governor oil pressure gauge and the oil pressure gauge of the oil pressure tank shall not differ too much.
(2)機組在停機過程中,應盡量縮短低轉速運行時間。當轉速下降至額定轉速的35%~40%時,可加閘制動。
(2) During the shutdown of the unit, the operation time at low speed shall be shortened as far as possible. When the speed drops to 35% ~ 40% of the rated speed, the brake can be added.
(3)機組在運行中,導水葉的開度限制應放在機組大出力的限制位置。當機組起動與系統并列時,如發現調速系統不穩定,可用開度限制使其穩定。在與系統并列后,可將開度限制放在機組大出力限制的位置。
(3) During the operation of the unit, the opening limit of the guide vane shall be placed at the limit position of the maximum output of the unit. When the unit is started in parallel with the system, if the speed regulation system is found to be unstable, the opening limit can be used to make it stable. After parallel with the system, the opening limit can be placed at the position of the maximum output limit of the unit.
(4)定期檢查主軸的擺度。
(4) Regularly check the swing of the spindle.
(5)機組運行中,還應定期做如下工作:
(5) During the operation of the unit, the following work shall also be done regularly:
1)定期切換壓油裝置的油泵和導軸承油泵,以防電動機受潮。
1) Regularly switch the oil pump and guide bearing oil pump of the oil pressure device to prevent the motor from moisture.
焦化發電機組
2)調速器各杠桿的連接處要定期注油。
2) The connection of each lever of the Governor shall be filled with oil regularly.
3)各汽水分離器要定期放水。
3) Each steam water separator shall discharge water regularly.
4)定期清掃橡膠水導軸承潤滑水的過濾器。
4) Clean the filter of lubricating water of rubber water guide bearing regularly.
5)機組備用時,定期做橡膠水導軸承備用潤滑水的投入試驗。
5) When the unit is in standby, the standby lubricating water of rubber water guide bearing shall be put into test regularly.
6)定期向蝶閥軸承注油。
6) Fill the butterfly valve bearing regularly.
焦化發電機組專注為您提供新鮮的行業資訊,更多的問題及精彩內容請關注我們的網站:http://pyucoin.com,我們會有更多的精彩內容為您
Coking generator set focuses on providing you with fresh industry information. For more questions and wonderful contents, please pay attention to our website: http://pyucoin.com , we will have more wonderful content for you
欧美成人社区| 亚洲一区二区视频| 日韩人妻一二三四区| 国产一区在线播放| 中文字幕av在线观看| 无码精品电影| 麻豆91视频| 国产二区无码| 久久精品视频免费| 91精品国自产在线偷拍蜜桃| 国产视频一区在线观看| 午夜无码一区| 日韩欧美性爱视频| 亚洲日本三级片| 99精品国产91久久久久久无码| 特黄A片| 99成人在线视频| 在线小视频| 麻豆射区| 草一次黄色av| 久久国产亚洲精品五月香婷 | 人人操摸99| 午夜激情视频在线| 欧美αV在线看| 国产毛毛浓密茂盛| 黄色小视频在线观看| 色一情一乱一乱一区91Av| 人妻中文字幕一区| 国产区在线观看| 性爱视频操| 一区二区三区四区亚洲| √8天堂资源地址中文在线| AV肉肉| 亚洲一区二区三区AV天堂| 人人专区人人操人人| 亚洲精品在线播放 | 天天干视频| 天天综合网~永久入口红桃| 丁香五月中文字幕| 91综合在线| 在线免费观看黄片|